That soft hiss of running water in the night. The tank that refills itself every few minutes for no reason. If your toilet keeps running long after you flush, the culprit is almost always the fill valve — and it’s a far cheaper fix than most people expect.

What the fill valve actually does
The fill valve is the tall plastic assembly inside the tank that lets water in and shuts it off when the tank reaches the right level. It opens when you flush, refills the tank, and closes again. When it can’t close properly, water keeps flowing — and that’s the running you hear.
Three reasons a fill valve won’t stop
1. A worn-out valve seat or diaphragm
Inside the fill valve, a small rubber diaphragm or valve seat does the actual sealing. After years in the water, it hardens, deforms, or collects mineral buildup — and water slips past it endlessly.
2. The float is out of position or damaged
The float tells the valve when to shut off. If it’s set too high, cracked, or waterlogged, the tank overfills and water keeps running down the overflow tube.
3. The valve is simply old
Fill valves are plastic and rubber. They work hard, cycling thousands of times a year. After roughly five years, most are past their useful life — and replacement is cheaper than repeated repairs.
Repair or replace?
Sometimes a quick adjustment of the float or a cheap diaphragm replacement fixes it. But if the valve is older or the seal is hardened, replacing the whole fill valve is the smarter move — they’re inexpensive, install in under an hour, and eliminate the problem for years.
Need a reliable fill valve? Sunwell Sanitary supplies fill valves, flush valves, wax rings and rubber seals for export. Contact Bella at belax@aoquanrubber.co or (086) 176-7998-0353.